Your Privacy Choices

As described in our Privacy Policy, we collect personal information from your interactions with us and our website, including through cookies and similar technologies. We may also share this personal information with third parties, including advertising partners. We do this in order to show you ads on other websites that are more relevant to your interests and for other reasons outlined in our privacy policy.

Sharing of personal information for targeted advertising based on your interaction on different websites may be considered "sales", "sharing", or "targeted advertising" under certain U.S. state privacy laws. Depending on where you live, you may have the right to opt out of these activities. If you would like to exercise this opt-out right, please follow the instructions below.

If you visit our website with the Global Privacy Control opt-out preference signal enabled, depending on where you are, we will treat this as a request to opt-out of activity that may be considered a “sale” or “sharing” of personal information or other uses that may be considered targeted advertising for the device and browser you used to visit our website.

7 ways to use AnkrRise

One template, seven jobs. The same precision rails do it all; you only swap the brackets or add an accessory.

1. Mark a plywood template

Mount the marking brackets, set the spacing from your plans, lay the AnkrRise on the plywood and trace every hole with a fine-point Sharpie. Drill, and your plywood template is ready.

Watch the marking video

2. Build a 2x4 formwork template

Use the AnkrRise as a master jig: assembly rods in the installation brackets, formwork brackets on the rods, then screw on your 2x4s. Remove the rods, and the AnkrRise is free for the next template.

Step-by-step guide

3. Use it directly in the formwork

Replace the plywood template with the AnkrRise itself. The 1.5 in clearance under the top rail lets a 2x4 fit flush underneath. Screw it at the ends or at the center, using the 5 marked spots on each rail. Pour from the center, then clean it and reuse it.

Videos and documentation

4. Set anchors on structural slabs

No formwork? Galvanized U-channel bars slide into the ends of the precision rails and lock with M6 wing screws. Cut and bend them to raise the template to the right height.

Shop U-channel bars

5. Mark drilling spots on concrete

Installing chemical or mechanical anchors in existing concrete? Set the marking brackets to your layout, place the AnkrRise on the slab and mark every hole at once.

Shop marking brackets

6. Check axis with a prism

The holes at the center of the rails take a prism. Use a traditional prism or the hands-free AnkrPrism and shoot your axis with the total station before, during and after the pour. Nobody has to hold it.

Shop the AnkrPrism

7. Verify or copy an existing template

Set the AnkrRise, with rods, over a plywood or 2x4 template to check the distances before, during or after the pour. Need a second template? Place the AnkrRise over the first one and copy the exact dimensions.

Compare kits

Which kit do I need?

The Starter Kit covers all seven methods (U-channel bars sold separately). Starting with a small or large AnkrRise? Add the brackets and accessories each method calls for.